You opened the bill and the usage number does not match anything you did. Nobody moved in. The sprinklers have been off since fall. And yet the number climbed.
Before you call the district to dispute it, there is a five-minute test that will tell you whether water is moving through your meter right now, and roughly where it is going. It costs nothing, and the answer decides your next step.
The Five-Minute Meter Test
Winter is the ideal time to run this, and that is not a coincidence. With irrigation shut down and no outdoor use, your household consumption is about as stable as it gets. A spike in January or February with the sprinklers off has very few innocent explanations left.
Shutting Everything Off and Reading the Low-Flow Indicator
Start by turning off every water-using thing in the house. No dishwasher, no washing machine, no ice maker filling, no taps running, and ask everyone to leave the fixtures alone for the next few minutes.
Now go out to your meter box, usually near the street or the sidewalk. Lift the lid, and if the glass is dirty, wipe it. Most residential meters have a small low-flow indicator on the face, often a little triangle, a star-shaped dial or a tiny spinning wheel. It is designed to pick up flow far too small to move the main odometer-style numbers.
Watch it for two full minutes. If it is completely still, no water is moving through your meter and you do not have an active leak on your side. If it is turning, even slowly, water is flowing somewhere in your system right now while nothing in the house is on.
Separating an Indoor Leak From a Service Line Leak
If the indicator is moving, do one more thing before you call anyone, because this step tells a plumber more than any description you could give over the phone.
Find your main shutoff valve, usually where the water line enters the house, and close it. Then go back and watch the meter again.
If the indicator stops, the leak is inside the house or in the plumbing downstream of that valve. If the indicator keeps turning with the main shut off, the leak is in the service line between the meter and your house, which is buried, outdoors, and on your side of the meter. Those are two very different jobs, and knowing which one you have before anyone arrives saves real diagnostic time.
What the Result Means and What to Do Next
Three outcomes, three different paths.
Indicator still, bill high. The water went somewhere earlier and is no longer flowing. Think about a toilet that ran for a week and got fixed, a hose left on, or an irrigation zone that cycled before winterizing. Worth reviewing, but there is nothing live to chase.
Indicator moving, stops with the main closed. The leak is in the house. Toilets first, then under sinks, then the water heater, then the lines you cannot see.
Indicator moving, keeps moving with the main closed. Service line leak. This one does not get better and will not surface in a way you notice until it has been running a long time. That is a leak detection call, because locating a buried line failure without tearing up a yard takes equipment.
Where the Leaks That Do Not Show Up Actually Hide
Every leak that damages a bill has one thing in common. Nobody saw it. Here is where they tend to live.
Toilet Flappers and the Dye Test
This is the most common silent water loss in any house, and it is also the easiest to confirm. The rubber flapper at the bottom of the tank hardens and warps with age until it no longer seats properly. Water seeps past it into the bowl continuously, and because it goes straight down the drain, there is nothing to see and often nothing to hear.
Test it in two minutes. Drop a few drops of food coloring into the tank, do not flush, and come back in fifteen minutes. If there is color in the bowl, the flapper is passing water and has been for a while.
Do this for every toilet in the house, including the one in the guest bathroom nobody uses. Those are frequently the worst offenders, precisely because nobody is in there to notice. If a flapper swap does not hold, the fill valve or the flush valve seat may be the issue, and toilet repair is a small job that pays for itself fast on a bill like this.
Service Line Leaks Between the Meter and the House
The pipe running from your meter to your house belongs to you, and it is the leak nobody plans for. It is buried, so a slow failure soaks into the soil and drains away without ever surfacing.
The clues are subtle. A patch of lawn that is greener than everything around it, or stays soggy when the rest of the yard has dried. A drop in pressure that came on gradually. A faint hissing at the main shutoff when every fixture is off. In our wet season, the soggy-ground clue disappears entirely, which is exactly why the meter test matters more here than the visual one.
Pressure Reducing Valve Failure
This one gets missed constantly. A pressure reducing valve sits near where your main enters and steps incoming pressure down to something your plumbing can live with. They wear out.
When one fails open, full municipal pressure reaches every fixture in the house. Usage climbs at every tap because more water moves per second. Toilet fill valves and faucet seals start weeping under pressure they were never designed for. And the temperature and pressure relief valve on your water heater may start discharging, which sends water straight to a drain where nobody counts it.
If your bill rose and you have also noticed banging pipes, unusually forceful taps or a water heater that drips at its relief line, get the pressure tested before chasing individual fixtures.
Irrigation That Was Not Properly Winterized
An irrigation system that still holds water through a freeze is a classic January surprise. A cracked valve body, a split lateral or a backflow device damaged by ice will leak continuously once the system repressurizes, and underground it leaks into soil you never walk on.
If your irrigation has its own shutoff, close it and rerun the meter test. If the indicator stops, you have found your answer without digging anything up.
What to Do With the Bill Once the Leak Is Fixed
Finding it is most of the work. Documenting it properly is how you may get some of the money back.
Why Documentation and Timing Matter
Many water utilities offer some form of one-time leak adjustment on a bill inflated by a genuine concealed leak. Terms vary a great deal between districts, and I would not want you to assume anything about yours based on what a neighbor in another jurisdiction got.
What is consistent is the shape of the requirement. These policies almost always ask for proof the leak was found and repaired, they almost always exclude losses from negligence like a hose left running or a misprogrammed irrigation clock, and they almost always have a deadline measured from the billing date. That last one is what catches people. They fix the leak, feel relieved, and get around to the paperwork two months later when the window has closed.
Call your water district, ask whether they have a leak adjustment policy, and ask what the deadline is. Do it the same week you discover the leak, not after the repair.
What a Repair Record Should Include
Whatever your district asks for, a complete record makes approval easier. Keep the dated invoice showing what was found and what was repaired, photographs of the failure before it was fixed, and the meter readings you took yourself, before and after.
Any reputable plumber will give you documentation that is specific about the problem rather than a one-line receipt. Ask for it at the time of service. Going back for it later is a hassle for everyone. Our leak repair write-ups are detailed enough to submit as they are.
The Leak Does Not Care That You Are Waiting for Next Month’s Bill
That is the instinct almost everyone has. Wait one more cycle, see if it corrects itself, then decide. Meanwhile the water keeps running, the next bill is worse, and if it is a service line or a slow leak inside a wall, the damage compounds quietly the entire time.
You can settle this tonight. Shut everything off, walk out to the meter, and watch the dial for two minutes. You will either go to bed relieved or you will know exactly what to do in the morning.
If that indicator is spinning, schedule a free estimate with Benjamin Franklin Plumbing of Redmond and we will locate it, repair it, and document it properly for your district.
Your Privacy Choices